Various national and international standards recommend potable water for mixing concrete; however, the availability of potable water is virtually a daunting task in some developing communities. Concrete workers in such environments tend to utilize any available water for mixing concrete, and this may be detrimental to the quality of the concrete being produced. This study investigates the rheological, mineralogical and strength variability of concrete due to construction water impurities. Water samples were collected from four different construction sites within Southwestern region of Nigeria for production of concrete. The physical and chemical properties of the waters were determined so as to measure their rate of contamination, prior to their use for mixing concrete. The rheological properties of the fresh concrete, compressive strength, split tensile strength, and microscale features...

One environment that hinders the performance of reinforced concrete is fire. In most cases, this results in the affected part or the entire structure being rendered useless or completely collapsing. When fire mishaps happen in structures, this is the case. This study reviews green structural retrofitting materials for reinforced concrete buildings in an effort to repair damaged structures in an environmentally friendly manner. The information gathered from earlier laboratory test results is assembled to comprehend the impact of room temperature strength properties and varied concrete mix material composition on the residual mechanical properties of concrete. The performance of various fibers, synthetic and natural, as laminate materials for concrete were evaluated, and the study showed that to a significant extent, distressed structural elements could be repaired with retrofits. However,...

In the earthquake-resistant design of overhead tanks, this research dealt with the determination of the response reduction factor applicable to overhead water tanks performing beyond the elastic limit. Eight existing water tanks were selected for the investigation and 127 ground accelerations due to 10 Indian earthquakes were selected. The magnitude of the earthquakes selected ranges from 4.5 to 7.2. Initially, 10.16 million nonlinear dynamic data of response reduction factor had been produced using Newmark’s β method by varying parameters. From the results obtained, multi-linear regression analysis was made to arrive at the empirical formula relating the parameters and it was found that ductility factor was the most significant factor among others such as damping ratio, pre-post stiffness ratio, natural period, and soil types, in influencing response reduction factor. Eventually, It ...

In this article some of the authors’ details were incorrectly published, as listed below. The fifth author’s family name, Velarde, was incorrectly written as Valarde, and the author’s affiliation was incorrectly specified as ‘Department of Civil Engineering, Universidad Peruana de Ciencias Aplicadas, Lima, Peru’. It should be ‘Department of Civil Engineering, Universidad César Vallejo, Lima, Peru’. The fourth author’s affiliation was incorrectly specified as ‘Department of Civil Engineering, Prince Mohammad Bin Fahd University, Al Khobar, Saudi Arabia’. It should be ‘Department of Civil Engineering, Covenant University, Ota, Ogun State, Nigeria’. The last author’s email address (k.prakash@utem.cl) was missing. The original article has been corrected.