Mechanical and sustaining properties of hydrabolt rock bolt plates

• Autor: Giraldo Paredez, Emiliano Mauro
• Formato: artículo
• Fecha de Publicación: 2014
• Institución: Universidad Nacional Mayor de San Marcos
• Repositorio: Revistas - Universidad Nacional Mayor de San Marcos
• Lenguaje: español
• OAI Identifier: oai:ojs.csi.unmsm:article/11497
• Enlace del recurso: https://revistasinvestigacion.unmsm.edu.pe/index.php/iigeo/article/view/11497
• Nivel de acceso: acceso abierto
• Materia: Plates; rock bolts; compression; traction; rock holding; Placas; pernos de roca; compresión; tracción; sostenimiento de rocas.

To determine the mechanical and supporting properties of the plates for Hydrabolt rock bolts, compression and tensile tests have been performed. The tests were carried out in the Materials Laboratory of the Pontificia Universidad Católica del Perú (PUCP), from which it is concluded that the plates that undergo less compression deformation are the corner plates, which deform 14.01 mm for a maximum load of 41.56 KN, while the refined plates deform 25.10 mm for the maximum load of 40.56 KN. The plates that are most deformed by compression and traction are the refined plates. The corner ones are the least deformed, 28.91% to compression and 28.40% to central traction. Also, the plates that undergo greater deformation by the traction in the ears are the sharp plates. It is noteworthy that it is not convenient for the plates to be very rigid, since as the tension in the massif increases, it will not be noticeable until a violent rupture occurs, which can result in a collapse. On the contrary, in a ductile plate, the increase in tension will be noticeable, which will make it possible to take the preventive maintenance or reinforcement provisions of the tensioned area