The influence of the ethanol/water molar ratio in the precursor solution on morphology and photocatalytic activity of pyrolytic ZnO films

• Autores: Quinta, María, Rodríguez, Juan, Sólis, José L., Estrada, Walter
• Formato: artículo
• Fecha de Publicación: 2005
• Institución: Universidad Nacional de Ingeniería
• Repositorio: Revistas - Universidad Nacional de Ingeniería
• Lenguaje: español
• OAI Identifier: oai:oai:revistas.uni.edu.pe:article/426
• Enlace del recurso: https://revistas.uni.edu.pe/index.php/tecnia/article/view/426
• Nivel de acceso: acceso abierto
• Materia: óxido de zinc; degradación fotoelectrocatalíitica; anaranjado de metilo; rociado pirolítico; zinc oxide; photoelectrocatalytic degradation; metil orange; spray pyrolisis

Zinc oxide films were fabricated by a home-made spray pyrolysis system equipped with an optical set-up ensuring the in-situ control of the film growth 0.1 M of zinc acetate diluted in a mixture of ethanol and water was used as the precursor solution. The deposition temperature and the pH of the precursor solution were kept at 350°C and 4.5, respectively. X-ray diffraction patterns revealed that films were zincite-like with a grain size depending of the ethanol/water molar ratio, Γ, in the precursor solution. The interference pattern obtained during film deposition was used to monito the film roughness: it was found that this is related with those results of surfaces and optical analysis obtained by scanning electron microscopy (SEM) and spectrophotometric measurements, respectively. Photo-electrocatalytic results indicated that there is a correlation of the partial molar volume of ethanol respect to water in the spraying solution with the photocatalytic efficiency of the ZnO films. We found that the maximum photodegradation of methyl orange in the solution occurs using ZnO films obtained with Γ equal to 0,12.