This thesis work begins with the revision of state of the art about active magnetic bearings (AMB), the mathematical methods used to obtain geometric and physical parameters that will influence in the mechanical, electrical design and control system proposed by this prototype. The control system will activate the magnetic bearing to center its shaft, for which it is joined a variable load in order to study the best control performance under different load over the rotor proposed by requirements. When the rotor is not controlled in its own axis even though variable load, a position error will occur that will be corrected by the program of a control system that will center the shaft (rotor). For this design was evaluated generalized AMB models [2], [3], [4] to validate the best identification for this design, furthermore as a consequence to get the best performance for the control system a...

This thesis work begins with the revision of state of the art about active magnetic bearings (AMB), the mathematical methods used to obtain geometric and physical parameters that will influence in the mechanical, electrical design and control system proposed by this prototype. The control system will activate the magnetic bearing to center its shaft, for which it is joined a variable load in order to study the best control performance under different load over the rotor proposed by requirements. When the rotor is not controlled in its own axis even though variable load, a position error will occur that will be corrected by the program of a control system that will center the shaft (rotor). For this design was evaluated generalized AMB models [2], [3], [4] to validate the best identification for this design, furthermore as a consequence to get the best performance for the control system a...

It is proposed in this abstract some suggestions for the manufacturing of advanced sensors (smart sensors) that are based in amorphous nanostructures in order to prepare intelligent sensors from which their transducers elaboration need specific requirements, such as in geometry and material of every sample. Moreover, it is quite important the correlation understanding between the necessities of the community or company that will operate with them. It means, the manufacturing of the transducers samples can be prepared by sputtering process, atomic load deposition and also by electrochemical reactions. Hence it is suggested to analyze the chemical components that are possible to find in the Andes mountains, also the strict compromise of the responsible residual collection of every production step and caring the environment conditions. Furthermore, it is proposed that designers could get un...