It is important that university students recognize different methods and study techniques; and moreover, analyze and incorporate them into their habits. Currently, one of the limitations for the future academic development, is the lack of knowledge of learning and understanding modalities, whose impact affects the academic performance. The objective of the study was to determine the level of association between study habits and academic performance of students from the second and third cycle of the Faculty of Nursing at the National University of the Altiplano in Puno, Peru. The sample of the study was based on 77 students, selected under inclusion and exclusion criteria. The research has a non-experimental, transversal and correlational approach. The study technique was the survey with its instruments of qualitative note taking and the Inventory of Study Habits, whose validity and relia...

El presente trabajo de investigación titulado “LA COMUNICACIÓN INTERNA Y SU RELACIÓN CON LA GESTIÓN DEL CAMBIO, ESCUELA HOGAR COMUNITARIA REGIONAL SAGRADA FAMILIA, VENTANILLA, 2018” tiene como principal objetivo, determinar la relación que existe entre la comunicación interna y la gestión de cambio en la Escuela Hogar Comunitaria Regional Sagrada Familia. El tipo de investigación es de tipo aplicada, el nivel de investigación es descriptivo correlacional, el diseño de investigación es no experimental y de corte transversal y de método Hipotético Deductivo, de esta manera en el estudio se hizo uso de la técnica de la encuesta, se utilizó como instrumento el cuestionario para ambas variables, comunicación interna y gestión del cambio, siendo aplicado a la EHCRSF con una población de 45 docentes, la muestra para el presente estudio de investigación es de tipo censal y...

In the Industrial Sector for the National Security, currently, the manufacturing of munitions for Governmental Entities is awarded to a single company: FAME S.A.C. Consequently, the development of an efficient and effective production of this company affects directly the supply of munitions in the national market. In the production area of FAME S.A.C., a high number of stops were detected in the production line of 9 mm of cases and bullets. These stops were caused to a greater extent by defective tools, from the Tooling Plant. As the tools were indispensable pieces in most of machines, this thesis analyzes in detail the causes of stops due to defective tools and proposes solutions in order to minimize the number of stops in the production line of 9 mm of cases and bullets. The following steps to reduce the number of stops in the line of 9 mm of cases and bullets of this thesis will start...